XtendLan GONU11B, Руководство пользователя

Страница: 11 / 11

GONU11B User’s guide
9
2.3 Network Cable Connection
Step 1
Insert one end of the network cable (RJ-45) into the 10/100/1000BASE-T or the
10/100BASE-T interface of the ONU.
Step 2
Insert the other end of the cable (RJ-45) into the RJ-45 port on the peer device.
2.4 Fiber Cable Connection
Before connection, please note:
Keep the optical connector and the optical fiber clean.
Make sure the bending diameter of the fiber is more than 6cm.Otherwise, the optical signal
loss may be increased, or even signals may be unavailable.
Cover a protective cap to guard against dust and water when the fiber is not used.
Step 1 Remove the protective cap of the optical fiber.
Step 2 Remove the protective cap of the ONU optical interface (PON interface).
Step 3 Insert the fiber into the PON interface.
2.5 Power Adapter and Cable Connection
Step 1 Connect the output end of the power adapter to the power socket on the ONU.
Step 2 Insert one end of the power cable into the input socket of the power supply adapter.
Step 3 Insert the other end of the power cable into a power outlet.
Step 4 Turn on the power-switch, then check whether the POWER LED is on. If not, check the
connection between the power cable and the adapter.
2.6 Verifying the Installation
After the ONU is powered on, check whether the PON interface status LED (Link) is on. If yes,
the connection is normal; otherwise check the connection of the optical fiber.
Environmental Protection
This product has been designed to comply with the requirements on environmental protection.
For the proper storage, use and disposal of this product, national laws and regulations must be
observed.