Step 1:
Enter into the Hyper Terminal. Click “ Start”
Æ
“Programs”
Æ
“Accessories”
Æ
“Communications”
Æ
“Hyper Terminal”
Æ
“aa.ht”, the Hyper Terminal interface in Fig, 3.1.4 will
appear.
Step 2:
Press “Enter” in Hyper Terminal, the prompt “
—
>” appear, as in Fig. 3.1.7. Under this
prompt the following operation commands to accomplish the setup of the parameters.
Fig. 3.1.7 Hyper Terminal command prompt
Input help, the supported configuration commands can be checked up, as in Fig. 3.1.8.
Fig. 3.1.8 to check command
The following is the introduction of getIp, setIp commands.
getIp
Function
：
to get the fixed IP, subnet mask, gateway, command port, IP address of PPPoE dialup
(the IP address of PPPoE will be 0.0.0.0 if there is no dialup or dialup is not successful).
Parameter: none.
Grammar format: Enter after input the command
Explanation: Please pay attention whether the inputting letters are capital or low case.
- 14 -
