PROBLEM
CAUSE
SOLUTION
There is no audio signal
when the soundbar is
connected to Bluetooth
®
The soundbar can’t be
connected to the
Bluetooth
®
Poor sound coming out
when connected to
Bluetooth
®
The remote control is
not working properly
The soundbar is not
paired to the audio source
The volume is too low
The audio source is
turned off
There is an existing device
connected via Bluetooth
®
The Bluetooth
®
connection is turned off at
the audio source
The Bluetooth
®
device is
out of the wireless range
The battery is exhausted
The remote control is not
pointing directly into the
IR receiver on the
soundbar
Check if the connection has been
established and in case it hasn’t,
pair the soundbar to your device
again
Increase the volume in the audio
source or in the soundbar
Turn on the audio source
Unpair the existing device and pair
the soundbar with the new device
Turn on the Bluetooth
®
feature in
the audio source
Place the Bluetooth
®
device closer
to the soundbar
Replace the battery
Point the remote control to the IR
receiver within the specified
wireless range
VII. Troubleshooting
3. Next, cycle to the Bluetooth
®
feature on the soundbar by pressing the
MODE button found on the right side panel and select it as the input source.
The blue indication will start blinking and a tone will be heard to indicate that
the soundbar has entered into the pairing mode.
4. Once the soundbar appears listed under the newly found Bluetooth
®
devices (XTS-810) of your wireless device, select it and wait a few seconds
for pairing.
5. When pairing is successful, the blue indication will stand still and a tone will
be heard indicating that the Bluetooth
®
is connected. If after 60 seconds the
pairing process fails, please repeat steps 1 through 5 described above.
6. You can now start streaming audio through the soundbar wirelessly from
your favorite Bluetooth
®
- enabled devices.
7. The soundbar will re-pair automatically to the memorized device when the
BT mode is selected on the unit after being turn off and on again.
Note: In Bluetooth
®
mode, the soundbar will automatically turn off if the unit
hasn´t been active for about 10 minutes.
In any of the other modes, the LED display will automatically turn off if the unit
hasn´t been active for about 20 minutes. The soundbar will become active
again as soon as any button is touched.
