XTBA “Product Name” Page 6 of 8
Product #01512 July 2014 © XTBA 1986 – 2015
SYSTEM OPERATION
Power Up Display
On power up the splitter will check the ten outputs. If a problem is detected e.g.
a short on the line the power led will flash for 30 seconds.
DISPLAYS
In normal operation following power up the View 10i/RDM will display the
following:
POWER
Red Led - Unit power. Shows that microcontroller and supply are active.
Green Led - DMX In. Shows if valid DMX is being received or will flash in
transmit mode.
Yellow Led – RDM traffic. Shows when the unit is receiving valid RDM data.
Yellow Led – next to clean port XLR, lit when clean port active.
Flashing RDM Yellow led – RDM Identify
Smart Splitter 10i/RDM View Supported Functions
XTBA’s UID = 2C2A (first two bytes)
Supported PIDs
Product Detail ID, Device Model Description, Manufacturer Label, Device
Label, Factory Defaults, DMX Personality, Personality Description, Reset
Device, Comms Status, Display Level.
Personalities
The splitter has six RDM settable personalities: The current personality can be
seen by using GET PERSONALITY DESCRIPTION or following power up via
the RDM led.
Personality 1 : Normal RDM Splitter
The splitter will pass through DMX levels and RDM requests and responses.
Personality 2 : Hold Last Frame
The splitter will retransmit the last valid frame in the event of data loss on the
input. RDM requests and responses will still be passed through.
Personality 3 : Clean Up All
The splitter will strip out any RDM data from the input data and only pass DMX
level information.
Personality 4 : Clean Up All + Hold Last Frame
As above but will hold the last valid frame on the input.
Personality 5 : Clean Port On
