Xstream AC5060B, Руководство по эксплуатации

Страница: 20 / 38

20
break-in of the pump
Break-In of the Pump
BREAk-IN OF THE PUMP
1. Make sure the power is connected at the power panel.
2. Check the oil level in the pump (see “Checking the Oil” in the
maintenance section).
3. Open the petcock (see F).
4. Turn ON the main power disconnect switch. Turn the pressure
switch to the AUTO position (see D). The motor should start. Allow
the compressor to run for 30 minutes, to break in the internal parts.
5. After about 30 minutes, turn the pressure switch to the OFF position
(see C).
6. Shut OFF the main power disconnect.
7. Close the petcock (see E). Turn in the clockwise direction.
8. Turn ON the main power disconnect switch. Turn the pressure
switch to the AUTO position. The compressor will start and fill the
tank to the cut-out pressure and stop.
NOTICE
• After about 30 minutes, If the unit does not operate properly, SHUT
DOWN IMMEDIATELY, and contact Product Service.
NOTICE
• As compressed air is used, the pressure switch will restart the motor
automatically.
NOTICE
• The pump is shipped with break-in oil which should be changed after
the first 8 hours of operation.
CAUTION
Escaping air and moisture can propel debris that may
cause eye injury. Wear safety goggles when opening
petcock.