Xstream AC5060B, Руководство по эксплуатации

Страница: 13 / 38

13
assembly
CAUTION
• On stationary models the shipping pallet is not designed as a base for
an operating compressor. Operating the compressor while it is on the
pallet will void your warranty.
Assembly
ASSEMBLING THE COMPRESSOR
1. Unpack the air compressor. Inspect the unit for damage. If the unit has
been damaged in transit, contact the carrier and complete a damage
claim. Do this immediately because there are time limitations to
damage claims.
The carton should contain:
• air compressor
• operator and parts manuals
2. Check the compressor’s serial label to ensure that you have received
the model ordered, and that it has the required pressure rating for its
intended use.
3. Locate the compressor according to the following guidelines:
a. For optimum performance, locate the compressor close to the
power panel, as specified in ELECTRICAL POWER
REQUIREMENTS, and as close as possible to the place where
the air will be used. This ensures maximum power to the
compressor and maximum air pressure to the tool. If both of
these conditions cannot be met, it is better to locate the
compressor close to the power panel, and use a longer air hose
or distribution line to reach the usage area.
b. The flywheel side of the compressor must be at least 12 inches
(31 cm) from any wall or obstruction, in a clean, well-ventilated
area, to ensure sufficient air flow and cooling.
c. In cold climates, locate the compressor in a heated building. This
will reduce problems with lubrication, motor starting and freezing
of water condensation.
d. Remove the compressor from the shipping pallet and place it on
the floor or a hard, level surface. The compressor must be level
to ensure proper lubrication of the pump and good drainage of
the moisture in the tank.
e. To prevent damage to tank and pump, the tank must be
shimmed so the pump is level within 1/8” per lineal foot
maximum to distribute oil properly. Fasten to floor and NEVER
force tank feet to floor without shims when tightening. We also
recommend the use of vibration pads (094-0137) under tank
feet (F).