Xsens MTi-3-DK, Руководство пользователя

Страница: 13 / 19

9 Document MT0605P.D
© Xsens Technologies B.V. MTi 1-series DK User Manual
Table 3: Connections on external power header (J100 in Figure 7)
Pin Description
1 VDDA
2 GND
3 GND
4 VDDIO
5 IOREF
The connections for
Arduino-compatible headers with a pitch of 2.54 mm (0.1 inch) are shown in Table
4. The MTi 1-series Shield Board does not support Arduino-compatible boards with an IOREF of 5V as
the maximum VDDIO is 3.6V for the MTi 1-s module. Therefore, the VDDIO is by default set to 3.3V.
This default VDDIO voltage can be overruled by placing a jumper on the external power header, but
only for voltages within the operational VDDIO range of the MTi 1-s module. For information on the
connections, refer to the pin description in Section 4.2. Refer to Table 6 on how to enable the various
interfaces on the Shield Board.
Table 4: Connections on Arduino-compatible header (P100, P101, P102 and P103 in Figure 7)
Pin Arduino Shield Board Pin Arduino Shield Board
P100-10 SCL/D15 SCL
P100-9 SDA/D14 SDA
P100-8 AVDD NC
P101-1 NC NC P100-7 GND GND
P101-2 IOREF IOREF P100-6 SCK/D13 SCK/ADD0
P101-3 NRST NC P100-5 MISO/D12 MISO/ADD1
P101-4 3V3 3V3 P100-4 MOSI/D11 MOSI/ADD2
P101-5 5V 5V P100-3 CS/D10 nCS
P101-6 GND GND P100-2 D9 PSEL0
P101-7 GND GND P100-1 D8 PSEL1
P101-8 VIN NC P102-8 D7 SYNC_IN
P102-7 D6 SYNC_OUT
P103-1 A0 NC P102-6 D5 SYNC_PPS
P103-2 A1 NC P102-5 D4 RESET
P103-3 A2 NC P102-4 D3 DRDY/CTS/nRE
P103-4 A3 NC P102-3 D2 RTS/DE
P103-5 A4 NC P102-2 TX/D1 RxD
P103-6 A5 NC P102-1 RX/D0 TxD
The
UART communication extension socket is not placed by default. When the socket is placed, it can
be used to directly plug an UART transceiver module of MikroElektronika like the ‘RS232 click’ or ‘RS485