8
www.XSscuba.com
XS Scuba MultiMax Breathable Inflator Service Manual
5. Remove the oral inflation assembly
a. Using a 5.5 mm socket or nut driver, remove
the nyloc nut.
b. Remove the exhaust seal (20)
c. Remove the oral button (24), spring (23), washer
(22), and o-ring (21).
If the oring (21) doesn’t come out with the oral
button assembly, it probably remains nestled in the
main body (8). Locate and remove it.
NOTE: If the o-ring does not come out on the
button shaft, it may still be seated in the main body.
Please locate and remove it.
6. Disassemble the breathing valve
a. Carefully pull off the dust cap (6).
b. Using a small, flat head screwdriver, disengage
the C-clip (7). Exercise caution not to bend it as it
will normally get re-used.
c. With your forefinger, push on the inlet stem to
remove the entire breathing valve sub-assembly
from the main body (8).
d. Separate the breathing valve assembly
i. While holding the valve housing (35) stationary
with a small crescent wrench, remove the inlet
stem (28) with a 13 mm open-end wrench.
