17
www.XSscuba.com
XS Scuba MultiMax Breathable Inflator Service Manual
i. Using a 5.5 mm socket or nut driver, drive the
nut (19) until there is one thread showing above
the nut (19). This is the preliminary adjustment.
j. Separate the valve assembly from the valve
assembly tool.
5. Assembling the inlet stem
a. Install a new, lubricated o-ring (29) on to the crown
orifice (30).
b. Install new, lubricated o-rings on to the inlet stem
(28).
c. Press fit the crown orifice (30), o-ring side first, into
the inlet stem (28).
6. Assembling the breathing valve
a. Thread the inlet stem assembly and the valve
housing assembly together. When doing this,
press down on the lever (37) to retract the seat (31).
This keeps the seat away from the crown orifice
(30), preventing unnecessary wear while the parts
are being rotated.
CAUTION: While mating the inlet stem assembly
to the valve housing assembly, press down on the
lever (37) to retract the seat (31). This keeps the
seat away from the crown orifice (30), preventing
unnecessary wear while the parts are being rotated.
