(-) Hood Input
Installation Type 8
(See the Vehicle Application Guide on page 2 to determine the installation type.)
Page 13
** Connect the Rearm wire only if the vehicle is equipped with automatic headlights.
*** Only supported if the vehicle has the function on the remote starter. It is also important to note that this function will not work when the engine is running.
* The Tach wire is an optional connection required on some remote starters not supporting tach signal in D2D.
Not required in D2D mode.
4
42
4
Programming Button
XK09
9: Red: (+) 12 V Input
10: Black: Ground Input
14: White: Data Bypass
12: Yellow/Black: Ground
20: Tan/Black: CAN High
19: Tan: CAN Low
6: Red/White: (-) Trunk/Hatch Input***
5: Blue: (-) Unlock Input
3: Light Green: (-) Lock Input
4: White/Violet: Aux 1 Passenger Slide Door Input***
2: Violet/Black: (-) Aux 2 Driver Sliding Door Input***
1: Blue/White: (-) GWR (status) Input
20
Pin 2, Purple
Pin 1, Brown
(-) Neutral Safety (DEI Platforms Only)
(+) Accessory
(+) Ignition
(+) Start
(+) 12 V Input
1: Red/Blue: Data Bypass
2: -
3: -
4: -
3: Gray: (-) Handbrake Sense Output
4: -
2: Green: (-) Door & Trunk Sense Output
1: Violet/White: (AC) Tach Output*
Remote
Starter
(-) Handbrake Status Input
(-) Door & Trunk Sense Input
(AC) Tach Input*
(-) Ground
13: Violet/Brown: (-) Hood Output
(-) GWR (status) Output
(-) Lock Output
(-) Aux 1 Passenger Slide Door Output***
(-) Aux 2 Driver Sliding Door Output***
(-) Unlock Output
(-) Trunk/Hatch Output***
Rearm (Autolight Off)**
(-) Parking Lights
(-) Parking Lights (at Light Switch)
+12VDC
CAN Low
Pin 5, Dark Blue
CAN High
Pin 4, Pink
(+) 12v
RX
(-) Ground
TX
(+) 12v
RX
(-) Ground
TX
XKD2D65
Ignition switch
7-pin transponder
connector
1
4
3
5
7
2
5
6
Rev.: 20120221
Platform: XK09
Firmware: DLPKHO
The Mobile Integration Systems
© 2012 Directed. All rights reserved.
