Vehicle Takeover
4
5
3
1
Press the remote start button on the transmitter to
start the vehicle.*
2
Press the PTS button twice to turn the
ignition ON.
Important:
Do NOT press the brake pedal.
Press the brake pedal, put the car
in gear and drive off.
Enter the vehicle, while making sure the
factory remote is inside with you. The
Push-to-Start (PTS) button will start
to flash.
Press the Unlock button on the factory
or aftermarket remote.*
2X
ENGINE
START
STOP
PUSH
Do NOT press
brake pedal
Ready to
drive off
Press
remote start
button*
Press Unlock
button on
either remote*
HOLD
&
OR
Flashes
ENGINE
START
STOP
* Your aftermarket remote may differ from the model shown in the illustrations.
Quick Reference Guide
DBALL2-HYUNDAI9
© 2017 Directed. All rights reserved.
Enter vehicle
with Smart Key
H
O
LD
Button(s)
Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
Press & hold for 1 second to remote
start.
Press & hold for 5 seconds to activate
the trunk release (optional).
Press once, then to activate the
rear hatch/tail glass release (optional).*
Press 3 times, then to activate
the panic mode.
Press once, then to reset the
remote starter runtime.
List of Available Commands
x1 +
x3 +
x1 +
* This output is configurable. see your authorized installation center for more
information.
Note that the information below is for Viper, Clifford and Python models. Icons and
commands may differ depending on the remote brand and model purchased. Refer
to your authorized installation center for more information.
Notes
Vehicle Takeover with Get In and Go*
4
3
1
Close the vehicle doors, hood and trunk, then press
the Remote Start button on the transmitter to start
the vehicle.**
2
Press the brake pedal, put the car
in gear and drive off.
Enter the vehicle, while making sure the
factory remote is inside with you.
Press the Unlock button on the factory
or aftermarket remote.**
Ready to
drive off
Press
remote start
button**
Press Unlock
button on
either remote**
OR
** Your aftermarket remote may differ from the model shown in the illustrations.
Enter vehicle
with key fob
GG
*
Get In and Go
connections required.
Get In and Go
Get In and Go is designed to provide users with easy takeover when
entering their Push-to-Start (PTS) equipped vehicle, once it has been
remote started.
Typically, users would have to remote start their vehicle, then get inside and press
the vehicle start button to perform a takeover. There is therefore a physical action
required to drive away. With Get In and Go technology, you simply remote start the
vehicle, unlock the doors, get in and go... Nothing to do but put the gear in drive and
enjoy your vehicle.
This unique feature monitors a variety of parameters such as the key fob, vehicle
speed sensor and door sensor, in order to perform takeover securily.
GG
Complete the following steps within 45 seconds
or the vehicle will shut down.
Notes
