Rev.: 20170814
Platform: DBALL2
Firmware
4
: HYUNDAI
© 2017 Directed. All rights reserved.
Page 7
Module Programming
1
Solid
2X
ENGINE
START
STOP
PUSH
Do NOT
press the
brake pedal
IMPORTANT:
NOT
Do
press the brake pedal.
the Push-To-Start (PTS) button
to turn
Press
twice
the ignition ON.
2
Important
Refer to the
Diagnostics section on page
for more information and for troubleshooting purposes.
LED
s 9-10
4
1X
ENGINE
START
STOP
PUSH
Press
the Push-to-Start (PTS) button
more to turn the ignition OFF.
once
You have successfully completed the
programming sequence.
module
Wait until the LED turns
solid red.
ON
Note:
To skip the transponder programming and use convenience features only, press
the
5 times. The
will turn orange then proceed to step 2.
programming button
LED
&
Flashes
3
The orange
flashes then the green
turns
for 3 seconds
LED
LED
ON
and shuts off.
Note
: When skipping transponder programming, the orange LED
flashes then the orange
turns solid green or orange for 3
LED
seconds and shuts off.
&
Off
Solid Green or
Orange x3 sec
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use Xpress
4.5 (and higher) or the Directechs Mobile app.
VIP
When the flashing operation is successful, you can proceed with the programming instructions below.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
D2D Installation
W W Installation
2
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
10-pin
D2D
1
st
4
th
12-pin
14-pin
2
nd
3
rd
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the
button.
Flash Module
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH
button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
oader3.
XKL
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select
and follow the on screen
FLASH YOUR MODULE
instructions.
