https://www.XPOtool.com
Item 63319
Page 5
The Tool Experts
05 2022-1
Control panel
Figure 1
Figure 2
№
Name
1
Power display
2
Power LED
3
Adjustment knob to adjust the output current
4
Connection point to welding gun
5
Connection point to power cable
6
Power switch
7
Fan
Installation
Attention!
When delivered, the welding machine is ready for use, a 0.8
mm welding wire is mounted.
When using a non-recommended welding wire, make sure that the size and type of that is suitable for
the contact tip of the welding gun, wire-feed control, and polarity of the device.
Adapting the wire feed
When delivered, the machine is prepared for use of 0.8 filler wire. Should you wish to use 1.0
mm wire,
the guide groove needs to be adapted. Adapt the guide groove as follows:
1.
Open the upper cover of the welding machine.
2.
Lift the pressure regulator
(1)
and remove the pressure control lever
(2)
from the feed roll.
3.
Remove the locking screw
(3)
of the feed roll by turning it counter-clockwise and moving it off
the roll.
4.
Remove the feed roll and observer the wire sizes engraved on either side of the roll.
5.
Insert the roll so that the engraved size on the side of the roll is directed towards you.
