https://www.XPOtool.com
Item 62834
Page 12
The Tool Experts
01 2022
-1
The cutting disc continues to run a little even after the device has been switched off. There
is a risk of injury.
Test run:
Always carry out a test run before the first cutting process and after every wheel change.
Switch off the device immediately if the cutting wheel does not turn smoothly, if strong vibrations occur
or if you hear unusual noises.
Handling
Before using the wall grinder, check the walls for hidden power cables and gas and water
pipes with a pipe locator.
1.
Switch on the wall grinder, hold the roller
(9)
against the wall when the cutting wheels are turn-
ing.
2.
Bring the cutting wheels into contact with the wall.
3.
The cutting direction should always be opposite to the direction of rotation of the wheels. Check
all markings
(14),
otherwise the device could get into an invisible area outside the cutting area.
4.
When reaching the end of the groove, remove the device from the wall. Remove the device from
the groove before switching it off.
5.
Finish the resulting gap between the two grooves with the hand chisel.
Cleaning and maintaining
Pull the power plug before carrying out maintenance or cleaning work on the device.
Have carried out by a specialist all work on the device not described in these operating
instructions. Only use original parts. Let the device cool down before performing any mainte-
nance or cleaning work. There is a risk of burns.
•
Always check the device for obvious defects before use, e.g., missing, worn, or damaged parts.
Realign screws and other parts if they have changed their alignment. In particular, check the
cutting wheels. Replace damaged parts.
•
Thoroughly clean the device after each use.
•
Clean the ventilation openings and the surface of the device with a soft brush or cloth.
Storage
•
Store the device in a dry place and out of the reach of children.
•
Cutting wheels must be stored dry and upright and should never be piled up.
