https://www.XPOtool.com
Item 62834
Page 10
The Tool Experts
01 2022
-1
Mounting
Attention!
Risk of injuries!
•
Make sure that you have enough space to work and that you do not endanger other people.
•
All covers and protective devices must be properly installed before commissioning.
•
Disconnect the power plug before you carry out any settings or maintenance on the device.
Attaching/replacing the cutting wheels
1.
Press the spindle stop
(7).
2.
Turn the take-up spindle
(16)
until the spindle stop fixes the take-up spindle. Press and hold the
spindle stop
(7).
3.
Loosen the clamping flange
(17)
with the clamping wrench
(13).
You can loosen the spindle
stop
(7).
4.
Remove the clamping flange
(17)
through the opening in the protective cover
(15).
5.
Remove the cutting wheel
(8)
by lifting the take-up spindle
(16)
and pulling it off as far as the
protective cover.
6.
Remove the flange
(21)
and the spacers
(20)
through the opening in the protective cover.
7.
Remove the second cutting wheel
(8)
as described in point 5.
8.
The mounting flange
(19)
can be left on the take-up spindle
(16).
When you remove the mount-
ing flange
(19),
make sure that it is positioned correctly. The contour of the mounting flange
(19)
must point towards the motor. When you turn the mounting flange
(19),
the take-up spindle
(16)
must turn with it.
9.
Place the required cutting wheel
(8)
on the mounting flange
(19).
10.
Set the desired cutting width by selecting the spacers
(20).
Slide the spacers onto the take-up
spindle
(16);
this is followed by the flange
(21)
and then the second cutting wheel.
11.
Put the clamping flange
(17)
back onto the take-up spindle
(16).
12.
Press the spindle stop
(7)
and turn the take-up spindle
(16)
until the spindle stop fixes the take-
up spindle
(16).
Tighten the clamping flange
(17)
again with the clamping wrench
(13).
You can
now release the spindle stop
(7).
Information on replacing:
•
Never operate the device without protective equipment.
•
Make sure that the speed indicated on the cutting wheel
(8)
is equal to or higher than the nom-
inal speed of the device.
•
Make sure that the dimensions of the cutting wheel match those of the device.
•
Only use cutting wheels that are in perfect condition (sound test: If you hit the cutting wheel with
a plastic hammer, you will hear a bright noise).
•
Never re-drill a receiving hole, that is too small, to enlarge it.
•
Never use separate sockets or adapters to be able to insert cutting discs with a bore, that is too
large, into the device.
•
Do not use saw blades.
Only replace the diamond cutting discs in pairs!
If the direction of rotation is marked on the cutting disc,
make sure that it corresponds to the direction of rotation marking on the tool.
Wear protective gloves when changing the wheels to avoid cuts.
