https://www.XPOtool.com
Item 61581
Page 5
The Tool Experts
05 2022-1
Mounting
Warning!
The manual ring roller needs to be attached safely before use.
1.
Place the device in the desired area of the
workbench.
2.
Make sure that you can operate the han-
dle comfortably, without any problems.
3.
Mark the drilling positions on the work-
bench through the two pilot holes
(A)
in
the device base
(25)
(see fig.).
4.
Remove the unit.
5.
Drill the holes into the marked spots on the
workbench.
6.
Mount the device with two screws, lock
washers, washers and nuts (in this order;
not included in the delivery).
Operation
1.
Determine the required ring size.
2.
Move the adjustable wheel
(16)
by turning the rotary knob
(29)
up or downwards.
3.
To bend a 2.54
cm (1″) ring, the adjustable wheel needs to be in the uppermost position.
4.
To bend a 5.08
cm (2″) ring, the adjustable wheel needs to be in the centre position.
5.
To bend larger rings, the adjustable wheel needs to be in the bottom position.
6.
Place the material between the upper drive wheel
(4)
and the adjustable wheel, as well as the
lower drive wheel.
7.
Turn the rotary knob clockwise to clamp the material between the wheels.
8.
Turn the handle
(15)
counter-clockwise to make the ring.
9.
To remove the made ring, turn the rotary knob counter-clockwise to loosen the clamping effect.
Maintenance
1.
Clean the device after every use with a
non-toxic cleaning detergent.
2.
The three lubricating points are the drive
shafts 1
(9)
and 2
(17)
as well as the ad-
justing shaft
(18).
Grease it with the help of
the grease nipples
(1)
(see fig.).
3.
Store in a dry area, out of reach from chil-
dren.