https://www.XPOtool.com
Item 61325
Page 3
The Tool Experts
07 2021-1
Introduction
Thank you for purchasing this quality product.
To minimize the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
•
Keep this product in a good working condition, take immediate action to repair or replace dam-
aged parts.
•
Only use approved parts. Unapproved parts may be dangerous and will void the warranty.
•
Keep children and unauthorised persons away from the work area.
•
Keep the work area clean, tidy, and free from unrelated materials.
•
Ensure that the work area has an adequate lightning.
•
Do not use the device to perform a task that it is not designed for.
•
Do not allow untrained persons to use the device.
•
Do not use the tool when you are tired or under the influence of drugs, alcohol, or medicine.
•
Dispose of waste liquids in accordance with local authority regulations.
•
Always read and comply with the warnings on the brake fluid container.
•
Wear eye protection and avoid contact with the fluid. If brake fluid gets into your eyes, rinse with
much water and seek medical advice. If you have swallowed the fluid, immediately seek medical
advice.
•
Warning!
Only use new brake fluid. Used brake fluid or other fluids will contaminate the system
and brake systems failure might occur.
•
Warning!
Do not discharge fluids in an uncontrolled way, by which the environment will be
polluted.
•
Warning!
Brake fluid is flammable
– keep it away from sources of ignition, including hot sur-
faces, e.g., exhaust manifold.
•
Warning!
Brake fluid will damage paintworks. Any spillage should be immediately flushed with
water.
Filling procedure
1. Make sure that no pressure remains inside the unit. Pressure can be released from the release
valve on the side of the pump.
2. Remove the cap on the top of the unit and fill the unit with new brake fluid. Make sure that there
is no remaining old fluid or debris in the tank.
Operating Instructions
1. Select a suitable adaptor from the selection provided with the unit. Install the adaptor to the
master cylinder of the brake system.
2. Pump the handle of the unit up and down until the recommended bleeding pressure is reached.
Open the brake nipple and connect it to the suitable bleeding container. Once the new fluid
comes into the container, close the nipple. Repeat the process on all 4 wheels (in any order).
3. When the brake fluid is flowing, ask a helper to pump the brake pedal while you watch the fluid
run through the clear tube. More than a few strokes may empty the master-cylinder reservoir,
so remember to keep checking it and top it up if necessary.
4. Once the process is complete, release the pressure by pressing down the release valve at the
side of the pump. After releasing, disconnect the fluid supply hose from the adaptor on the
master cylinder.
Note!
Do not disconnect the adaptor before releasing the pressure.
5. If necessary, top up the brake fluid in the reservoir to the maximum level. Replace the master
cylinder cap on the vehicle.
6. Safely dispose of the waste brake fluid in the bleeding container.
