XPOtool 61054, Руководство по эксплуатации, Страница: 10 / 11

© by WilTec Wildanger Technik GmbH Item 61054 Page 10
http://www.WilTec.de
http://www.aoyue.eu 04 2022 -1
http://www.teichtip.de
Carbon brush replacement
When the carbon brush reaches its wear limit, you need to replace it. Unscrew the carbon brush cover
screw with a flat-tip screwdriver and remove cover. Replace the original carbon brush with a new carbon
brush in the brush holder. Replace the cover and screw on the brush cover again.
Note:
•
The biggest advantage of the sander is: it has a vacuum system inside, thus no vacuum cleaner
is needed. When we tested it, the sanding pad surface could be pasted onto the wall without
needing to be hand-held.
•
It has a special design on the shaft which is connected with the sanding pad. When the sander
is sanding an uneven surface, the outside plastic pad is as a horizontal, the sanding pad could
adjust the height to finish perfect sanding.
•
Inner structure: two walls protect the engine against dust.
•
The dust collection bag has small hole, which will help the wind to be released. If the bag is
50
% full of dust, please clean up the dust timely.
•
When you finish the sanding, please let sanding pad still touch the working surface for seconds
to let the dust suction be completed by the sander.