Xpelair C6S, Инструкция по установке и обслуживанию

Страница: 6 / 8

For Australia Only –C6TS / C6TR / C6HTS / C6HTR
These models are permanently connected to the supply and opera ti on is controlled by a remote switch. They should be directly
wired to the supply through an approved 10A wall mounted surface switch with at least 3mm clearance between contacts.
1. Remove the front cover/ba ffl e assembly by depressing the latch on the underside of the cover and pulling o ff the front
cover / ba ffl e from the bo � om (See Figure C).
Mark the posi tio n of the back-plate
2. Hold the back-plate so that the level line marked on it is orientated horizontally.
3. Carefully insert the fan tube into the wall duct.
4. Mark on the wall the pos i� ons of the fixing holes in the back-plate.
5. Remove the back plate from the du c� ng.
6. Drill screw holes in these posi � ons if necessary, and fit wall plugs and screws as required. The fan may also be fix ed
to a wall tube using the clamping brackets. See 9 below.
Mount the back-plate.
7. Feed the mains cable through the cable entry hole in the back plate to the terminals.
8. Insert the fan tube of the back-plate into the wall duct/ceiling as before.
9. Fasten the back-plate to the wall/ceiling using appropriate fasteners. See figu re A.
10. If using screws, do not over �g hten. The fan may also be fix ed to a wall tube using the clamping brackets. Tighten the
screws un �l the fan is fi rmly secured to the tube – see fi gure B.
11. Make sure the mains supply is isolated. Switch o ff the mains electrical supply and remove fuses.
12. Feed the cable to the terminal block. Wire the fan as shown in Figure F using the diagram appropriate to the fan
model.
13. Connect the cable from the isola � ng switch to the electrical supply wiring.