12 |
P a g e
(Press Head Support Beam)
Do Not remove or loosen the bolts attached to the Air Cylinder as shown on the left
(above).
Using the proper size, open end wrench or socket combination, loosen the 4 ½-13 bolts
that support the Press Head as shown on the right as indicated in the photo above.
CAUTION
must be used to only
loosen these bolts
, as the Press Head is HEAVY and
could slide to the bottom of the slots.
Reconnect the Air Supply. Once the Air Supply is reconnected the Press Disk should
immediately
extend – extending the Press Plate down onto the closed pail and pushing
the entire Press head assembly up in the slots. (If the Head does not move up the bolts,
they are too snug. You will need to loosen them more).
View the gap between the Press Head and the top of the pail. If required, use a plastic
mallet to adjust the Press Head bracket up, down, left or right, to position the Press
Head parallel with the top surface of the CLOSED pail.
Once you are satisfied with the alignment, tighten all 4 of the ½ - 13 bolts and remove
the main air supply.
Swap the Air Lines back on the valve to Tube A to Port A, Tube B to Port B. Re-apply
Main Air and test.
