22
OpP set
OpP = 660
This screen allows the adjustment of the Over Current trip point. Turn either the voltage or the current control to adjust the
value. Press the output on/off button when the value you wish is displayed. When the output on/off button is pressed the
following screen will be displayed:
System set up
Over limits set
This screen allows the adjustment of the Over Power trip point. Turn either the voltage or the current control to adjust the value.
Press the output on/off button when the value you wish is displayed. When the output on/off button is pressed the following
screen will be displayed:
System set up
exit
To change another setup item at this time you may use either rotary control to select that option. To exit setup, rotate either
control until the following screen is displayed then press the output on/off button.
Save config?
yes
Save config?
no
The following screen will be displayed.
Rotating either control will alternate between the screen above and the screen below.
When the desired option is displayed press the output on/off button. Selecting YES will save any Setup changes to non-volatile
memory and they will be retained even when primary power is cycled. Selecting NO will not save Setup changes to non-volatile
memory and they will be in effect only until the unit is turned off.
The power supply will return to normal operating mode at this time.
