XP Metal Detectors Deus V4, Руководство пользователя

Страница: 38 / 52

INCORRECT CORRECT
When detecting, it is important that you sweep the coil parallel to the ground, using wide movements,
as close as possible to the surface (without actually touching it). Proximity to the ground will increase
the likelihood of detecting a deep target and will enable the most discreet objects to be identified
more easily. You are advised to avoid knocking the coil, as although it is designed to tolerate this kind of
stress, careful treatment will prolong the life of the device and guarantee you better perception of targets.
36
PRACTICAL INFORMATION
When you are detecting, you are free to choose the rate at which you move.
For example, if you prefer to cover a zone at high speed while detecting, this will certainly give you
a global ‘snapshot’ of the site. However, it is clear that this way of detecting will also leave large
areas of ground unexplored between each sweep. On the other hand, if you insist on closely
scrutinising every inch of the ground, you should ensure that each sweep slightly overlaps the
previous one, in order to reduce to a minimum the area that your coil has not scanned.
You should also bear in mind that you will further increase your chances of finding and identifying
a target by sweeping more slowly. This particularly applies in metal-infested ground (when there
are more targets to be sorted) or when you are searching for deeper targets.
Target
Once the detector has indicated the approximate presence
of a target in Motion mode, if you are having difficulty
locating the target then sweep the place where you heard
the sound. Slowly reduce the amplitude of your move-
ments and make a mental note of the spot where the
sound is loudest. If necessary, indicate it with a mark on
the ground. Then move a quarter turn around the spot and
begin sweeping again in the same way (at 90° to the first
sweep). You should then locate the precise zone contai-
ning your target at the intersection of the two sweeps,
where the sound is loudest. Continue with crossed
sweeps over the target. The loudest and highest pitched
audio signal indicates the centre of the coil and therefore
the position of the target.