Remove the safety screw and press the lever at the base of the handle to swing open the battery
door. Install the two batteries according to the orientation stated inside the battery compart-
ment. After battery installation, close battery door and tighten safety screw.
Press in the power button on the control panel on top of the transmitter. The LED around the
power button will glow after power on. If not, power off the transmitter and re-check the instal-
lation of the batteries. A flashing LED means low batteries and needs to be replaced.
Always power on the transmitter first and the car second. Your transmitter will automatically
link (connect) to your car. If you are running two or more cars at the same time be sure to pow-
er on the car one at a time. If not you may link to the wrong transmitter.
OPERATION
On / Off
Switch
Power
Button
1. Charge the car battery.
2. Power on the transmitter.
3. Turn on the car using the switch on the bottom.
4. Place the car on a smooth surface and have fun!
5. When the vehicle starts to slow down, the battery is getting weak and you should stop driving.
6. Allow the car and battery to cool before recharging.
7. Make sure to turn off both transmitter and car after each use.
DRIVING CONTROLS
Steering
Wheel
Forward / Reverse
Trigger
5
