Xo SINK PRO NANOGRIND XOD1HP, Инструкция по эксплуатации и установке

Страница: 4 / 12

HOW THE SINK FLANGE ASSEMBLES
www.xoappliance.com
SINK
SINK FLANGE
THIN RUBBER GASKET
or PUTTY
FOAM RUBBER GASKET
(plastic side facing down)
SUPPORT RING
SINK FLANGE GROOVE
MOUNT RING
CUSHION MOUNT RING
CUSHION MOUNT GROOVE
AFTER ENSURING THAT THE SEALING SURFACE OF THE SINK IS COMPLETELY CLEAN:
1. Assemble the Sink Flange in the following order.
a. Disassemble the Sink Flange assembly from the disposer by rotating the Mount Ring clockwise.
b. Push the Mount Ring up and remove the rubber Cushion Mount Ring . Take a minute to see
how the Cushion Mount Ring seats into the groove on the Sink Flange .
c. Unscrew the Support Ring from the Sink Flange and remove the Foam Rubber Gasket leaving
the Thin Rubber Gasket in place. (The rubber gasket can used instead of Plumbers Putty on
Stainless Steel sinks. Cast sinks may require the use of putty to ensure a good seal)
d. If putty is required to make a good seal, First remove the Thin Rubber Gasket - apply a ring of
putty around the underside of the Sink Flange and press firmly into place, squeezing the excess
putty out around the edges.
e. ONCE THE SINK FLANGE IS IN PLACE, DO NOT ROTATE - This can cause leaks.
f. From underneath the sink install the Foam Rubber Gasket (plastic side facing down) around the
Sink Flange and push it up snug against the sink.
g. With the arrows pointing up, thread the Support Ring in place and hand tighten compressing the
Foam Rubber Gasket in place.
At this point it is advisable to insert the drain stopper and fill the sink with water to test for leaks.
h. Place the Mount Ring over the Sink Flange and push it up as far as it will go.
i. While holding the Mount Ring in place, re-install the Cushion Mount Ring . The larger diameter
portion of the Cushion Mount Ring should be at the bottom and the inside groove of the Ring
should match up with the groove and lip at the bottom of the Sink Flange .
When you are done, the Mount Ring should sit on top of the Cushion Mount Ring and turn freely.