3. Wire the power supply
a. If you are in the US, ensure the switch on the side of the power
supply is set to 110V
b. Make sure all wires are disconnected from the wall outlet and Lorei
before wiring. Do not connect the power supply to an outlet until the
instructions have been followed thoroughly.
c. Lift Plastic Protector to access the connection points
d. In order to attach the cables to the power supply, use a screwdriver
to loosen the screw on the terminal enough to slide in the
corresponding connector. Push the corresponding wire terminal
into the slot as far as it will go. While holding it in place, tighten the
screw back down to secure the connection.
