18
19
Installing the Vent Mount:
1
Locate a vent with horizontal
louvers sturdy enough to hold your
PowerConnect Vehicle Dock and Radio .
2
If the vent louvers in your vehicle are
recessed, you may need to use the
longer vent clamps with the Vent Mount .
If so, remove the shorter vent clamps
and install the longer ones into the Vent
Mount . Be sure to observe the orientation of the vent clamps
as shown .
3
Push the Vent Mount onto the vehicle vent as shown (1) until it hooks on
the rear of the vent louver (2) .
4
Rest the foot against the bottom of the vent (2), and adjust the tilt of the
Vent Mount by repositioning the foot to a different adjustment hole (3) .
To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .
PUSH
Dash
Vent
Louver
Foot
Vent
Vent
Dash
Dash
HOOKED
TILT
ADJUSTMENT
HOLES
1
2
3
Slide Short Vent Clamps Out
Remove End Cap
Slide Extended Vent Clamps In
Replace End Cap
Extended Vent Clamps
Short Vent
Clamps
Vehicle Installation
Содержание EDGE
