Chapter 1 - Point&Scroll Mouse
Chapter 1 - Point&Scroll Mouse
Installing the Point&Scroll mouse
1. Power down your Power Mac and locate an unused USB
port. Taking the USB connector from the Point and Scroll,
carefully insert the connector into the USB port on your
Power Mac (it will only go in one way).
2. Unplug your old mouse from the Power Mac, or you may
leave it plugged in if you prefer, and power up your system.
3. Once the installation is complete, you must restart your
Mac to use your Point&Scroll.
Configuring the Point&Scroll software
1. Locate and launch the XLR8 Point&Scroll control panel
in your Control Panels folder.
2. From this panel, you may configure both the left and
right mouse buttons to preform several different functions.
3. Once you have configured your buttons, close the control
panel to save your changes. A restart is not necessary to
begin using your new mouse.
Installing the Point&Scroll software
The XLR8 Point&Scroll and the Interex USB Scrolling
Mouse are supported on all Power Macs and clones equipped
with USB.
After booting your Macintosh, insert your XLR8 CD-ROM:
1. Open the Point&Scroll folder.
2. Review the ReadMe file on the disk for any last minute
changes or updates.
3. After saving the folder, open the Point&Scroll folder and
launch the installer.
After installation, you will be prompted to restart your com-
puter. Instead, select "Quit".
