XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98
Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, [email protected]
Page 4
4.
Installation
4.1.
Package Contents
1x XLifter EAS installation
1x Cable harness with the bypass connector
1x XLifter control module
1x Velcro strip for easy control module installation
1x User and installation manuals
1x XLifter sticker
4.2.
Installation - general description and overview
The XLifter device consists of 2 main components - the control module and the EAS
installation unit (EAS stands for Electronic Air Suspension). The control module (display
unit with buttons) is used to control all settings and to inform the user of the operating
status. The EAS unit serves to adjust the wheel height sensor signals and vehicle tilt
measurements. Communication of the control module and the EAS unit is wireless.
The control module is installed anywhere in a suitable place in the interior of the vehicle.
The control module needs to be connected to an ignition-switched 12V power supply
(cigarette lighter socket). Advanced users may cut the power connector and connect the
cable to appropriate 12V junction point. Installation with all cables hidden will look more
aesthetically and the lighter socket will not be blocked.
The XLifter EAS unit is installed near the original air suspension control unit and connects
with it via the supplied cable harness. The XLifter EAS unit is mechanically attached to the
body of the vehicle after installation, thus serves also as an accurate tilt sensor.
Quick installation overview in 5 steps
:
1.
Install the XLifter EAS unit and connect the cable harness
2.
Plug the control module power to 12V socket
3.
Set the appropriate vehicle type (D3, D4, RRS)
4.
Set the Steering position (left or right-hand side)
5.
Perform the calibration procedure
