Xinje TS Series, Руководство пользователя

Страница: 24 / 27

10
(5) Install the rear cover of the module removed in step 1.
Notice:
(1) 4G or WIFI modules cannot be disassembled with power, and the HMI must be powered off before
installation.
(2) The SIM card of the 4G module cannot be plugged or unplugged with power. Please install it in the direction
shown on the module.
2-4-3. Product installation and using environment
1. Installation requirements
TS5L series HMI is equipped with four iron mounting brackets at the factory. The upper and lower sides of the
display are respectively provided with two square fixing holes. The display is tightly fixed to the mounting holes
of the control cabinet with the mounting bracket.
In order not to cause the temperature of the HMI to be too high when working for a long time, it is better to
reserve 10cm space above and below the HMI and 5cm space left and right during installation to ensure smooth
air convection.
2. Installation steps
(1) According to the dimensions in the previous section, open a rectangular mounting hole on the panel of the
control cabinet.
(2) During installation, a sealing ring is added in the sealing groove.
(3) Insert the bottom of the display into the mounting hole of the control cabinet.
(4) Insert the mounting bracket into the side fixing hole of the display and tighten the screws.
(5) Connect the HMI and PLC communication port with communication cable.
The communication cable can be provided by the manufacturer or processed by the user according to the
connection diagram, and can start to work after being connected to the +24V DC power supply.
3. Environmental factor
Please install and use correctly within the specified environment.
【
Note
】
: Do not use it in a dangerous environment full of flammable gas, water vapor or dust, and do not install it in an
environment where the temperature changes too fast or the humidity is high, otherwise it will cause moisture
condensation inside the HMI.
4. Power supply requirement
TS5L series HMI can only use DC power supply. The power supply specification is DC+24V (voltage range:
22V~26V), which conforms to the standard of DC power supply for most industrial control equipment. Connect
the positive pole of the DC power supply to the "+24V" terminal and the negative pole of the DC power supply to
the "0V" terminal. As shown in the figure below: