Xilinx Kintex-7 FPGA KC705, Руководство по началу работы

Страница: 17 / 29

KC705 Getting Started Guide www.xilinx.com 17
UG913 (v4.1.1) March 7, 2014
Introduction
Running BIST tests
10. A Web server-based BIST demonstration can also be run on the same hardware to test
different peripherals. Enter these commands at the XMD prompt to run the BIST
demonstration:
XMD% stop
XMD% dow board_test_app_Webserver.elf
XMD% con
11. Reload the Web page with the same URL (192.168.1.10). The Web page should appear
as shown in Figure 1-7 .
12. The left side of the Web page has different options for selecting the type of test to run
on the hardware. For running any test, click the radio button corresponding to the test.
The bottom of the Web page has a messaging section that displays the results of the
tests.
The Video and BIST demonstrations using the KC705 board are complete. Because a fully
configured MicroBlaze processor subsystem has been provided, the user can start
developing embedded applications. Because an FPGA is being used, the processor
subsystem can also be fully customized. To do this, the Xilinx Design Tools and the
USB-UART driver must be installed on the computer (see
Appendix B, Installation and
Licensing of Xilinx Design Tools ).
X-Ref Target - Figure 1-7
Figure 1-7: BIST Demonstration Web Page with DDR3 test results
UG91 3 _c1_07_0 8 0912
Send Feedback