XIEGU X108G, Руководство по обслуживанию

Страница: 8 / 36

3.2.6 Power prime amplifier
P2 outputs a transmitting small signal, this small signal
is connected to the socket P4B on the power supply
board by IPEX wire, and it is prime amplified by Q5B
(2SC5551), then output by the T6B.
3.2.7 Power amplifier units
Power amplifier units are composed of Q4B
、
Q3B
、
Q1B
、
Q2B. Q1B and Q2B are final stage power
amplifier
，
Push-pull amplifier are made up of 2pcs
RD16HHF1
，
stable output around 18W power signal.
T2B is final stage output transformer.
The bias voltages of each level power tubes are all
generated and supplied by a pedestal generator which
consists of Q7B and U6B.
3.2.8 Low pass filter
The 6 stage, 5th order elliptic low-pass filter which is
composed of relay and magnetic winding is responsible
for filtering and removing the spurious and harmonic
signals which are generated by the power amplifier,
and U3B, U4B and U9B control the band switching.
3.2.9 Power/Standing wave detector
The power/SW detector is composed of T1B, T7B, D1B,
D2B etc. It detects the output of antenna port and
reflected power, U5B buffs and amplify the tested
output signal, then sent to the microcontroller for
processing and display the power and SW value.
3.2.10 Automatic power control circuit
The forward power detection value and the setting
power value are sent into the U22A at the same time
to process automatic power control, and output VALC
voltage to control the amplification of the Q3, so as to
achieve the purpose of automatic power control.
3.3 Control unit / Interface circuit
3.3.1 Microprocessor unit
Microprocessor U17 controls the whole work of
the machine. Its I/O signal is mainly divided into
switching signals and digital signals.
Microprocessor comes with AD/DA converter. The
inside detection signal, such as S table, forward power
and back power, are input to inside the processor to
read by a special ADC port.
The microprocessor expands the I2C memory U8 to
store the related data information.
3.3.2 External interface circuit unit
X108G has the following external interfaces: AUX,
KEYER, ACC, SPK, Micro-USB.
Micro-USB is the real USB connector and it connects to
the processor U17.
Key interface KEYER is common interface for
manual/automatic key, connects to processor U17.
BAND BPF LPF
3.5~4.0M
B6
B1
B2
B3
B4
B5
L1
L2
L3
L4
L5
BAND SELECTION TABLE
L6
1.8~2.0M
B7
B8
B9
B10
CODE
0000B
0001B
0010B
0011B
0100B
0101B
0110B
0111B
1000B
1001B
10~10.2M
14~14.5M
18~18.2M
21~21.6M
24.8~25M
28~28.8M
5~5.5M
Non-HAM-BAND
7~7.3M
B11 1010B
C107B
100nF
R65B
1k
+6REF
+9T
R66B
3.9k
C100B
100nF
RW5B
NC
R67B
2k
1
TP5B
NC
RT1B
NC
R68B
NC
R34B
680R
C95B
10uF
U6B
TL431CPK
Q7B
BC868