TUTA-B1 GSM REMOTE CAMERA USER MANUAL
30
TUTA camera will send out SMS alarm message only.
•
If the sensor is set
“
send alarm via SMS only when it alarm
”
by this command
successfully, the user can not use command 64, 65, 66 and 67 to change
alarm way of the sensor.
3. When TUTA camera has received the SMS command, it will emit a
“
Beep
…”
tone and the indicator will flash red and green alternately. TUTA camera will
then send a notification message via SMS to the user(s) stating
“
Waiting to
load wireless sensor, make the sensor work immediately.
”
4. The user needs to make the sensor work and transmit signal to be studied by
TUTA camera.
E.g. For a wireless door magnet, open and close the door once to send the
signal to the camera.
5. When TUTA camera receives the sensor signal, it will emit a
“
Beep
…”
tone and
send a notification message via SMS to the user(s) stating
“
*** has been
successfully loaded
”
6. To exit the loading mode manually, press the
set
key of the camera, TUTA
camera will emit a
“
Beep
…”
tone and exit the loading mode.
L
Failed SMS reply
•
If TUTA camera failed to load the sensor, the indicator light on TUTA camera
will flash red and green alternately for approximately 60 seconds, TUTA
camera will revert back to the preset armed/disarmed mode.
•
When the maximum amount of sensors is already loaded, if a user attempts to
load one more sensor onto the camera, TUTA camera will send a SMS
message
“
Sensor list is full. Please delete old sensor at first.
”
•
TUTA camera will emit
“
Beep, Beep
…”
tone if the user want to load an existed
sensor which has been loaded onto TUTA camera.
4.10.2 Remove wireless sensor
Authority:
Master
and
family
users.
Ì
Method
The user sends following SMS message in order to:
Remove a wireless sensor: (40)
#112#
SensorDescription
#...#
SensorDescription
#
•
Sensor description
should be the existing sensor which the user wants to
remove.
Remove all wireless sensors:
#112#
(41)