Mechanical Key Cutting Machine CONDOR XC-009
6.1.2 Shoulder spacing
The original key is fixed on the accessory clamp, the shoulder spacer is aligned, then the
blank key is aligned to the shoulder spacer, clamped, and finally the shoulder spacer is
rotated to the initial state.
If it is found that the distance between the shoulder position and the fixture is
inconsistent, it is necessary to calibrate the shoulder spacer. As shown in the following figure,
installed the alignment block (refer to chapter 5.3), rotating the shoulder spacing axis, make
the left and right shoulder spacer just close to the alignment block A angle, if there is
deviation, release the set screw. Slowly move the shoulder spacer, and adjusted the spacer in
correct position, then lock the set screw tightly. Remove the key spacer that it can be used
normally.
