Mechanical Key Cutting Machine CONDOR XC-009
5.2 Cutter Installing
1)
While the machine is stopped, slowly rotate the spindle, align the spindle pin hole
with the host pin hole, and then insert the tool change rod into the end.
2)
Installing the cutter on the spindle. Pay Attention to the front and back surface of
cutter (with the word facing left), install the cutter block and lock nut (anti-nut).
3)
Use the 19mm open spanner to tighten the lock screw counterclockwise. Then
pull out the tool change rod. After installing the cutter, please refer to chapter 5.3 Fine
Adjustment Slide Calibration.
