Precision Driven Audio
Specifications
BMW42C
RMS Power
75W
Max Power
300W
Impedance
4Ω
Response
90Hz-22kHz
Sensitivity
83.2dB
Recommended HP X-over Frequency
120 - 200Hz
Diameter
4’’(100mm)
Mounting Depth
1.0’’(25mm)
All specifications are subject to change without notification due to continual product improvements.
XFIRE AUDIO OEM Series Components are designed for high quality sound systems. To get the highest performance from
your XFIRE AUDIO OEM Components we recommend:
•
To use 2-channels of an XFIRE AUDIO XFR1200.4 or XFR2000.4 amplifier to power the BMW42C system.
•
Make sure the active High Pass filter of the amplifier channels driving the BMW42C system is adjusted to the
recommended frequency (see specifications above).
How to install the BMW42C:
1
Unscrew the door panels from the front doors of the car, check that you unscrew all hidden screws too.
2
Now carefully unclip all the clips of each door Panel.
3
Disconnect the power windows connector, the door light and the door handle and take off the door panels.
4
Unscrew the 3 screws of the original speaker, disconnect the wires of the speaker and take out the speaker.
5
Use damping material to prevend resonation of the doors and door panels.
6
Connect the speaker wires to the BMW42C speakers, observe the right polarity!
7
Install the BMW42C speakers in the original locations.
8
Run the following wires from the XFIRE AUDIO amplifier to the under seat woofer locations:
•
1 set Amplifier Input wires - connect to the two thicker wires (plus and minus)
•
Amplifier Door Speaker output wires - connect to the two thinner wires (plus and minus)
•
Amplifier Woofer Speaker ouput wires - connect directly to the BMW80W woofers
9
Install the door panels back and stick the included XFIRE logo’s on the original grills.
Installation
