Xerox Wide Format 6030, Руководство пользователя программного обеспечения

Страница: 80 / 86

72
Chapter 3 System-Related Precautions and Limitations
„
Windows 98 and Me Setup
Protocol installation
It is necessary to install the protocol that is installed in Windows 2000 into
Windows 98 and Me computers in order to enable these two systems to
communicate. Either of the TCP/IP, NWLink and NETBEUI protocols are
acceptable for this.
Microsoft Network Client installation
It is necessary to ensure that the [Microsoft Network Client] is installed in order
for Windows 98 and Me computers to use a shared printer on Windows 2000.
Follow the steps shown below: [Control Panel] > [Network] > [Add] > [Client] >
[Microsoft] > [Microsoft Network Client].
Printer creation
When installing
Windows Driver
, specify the name of the shared printer that
resides in the Windows 2000 computer on the network (the name of the shared
printer that transmits with LPR to the Xerox printer created previously in "
„
Windows 2000 Setup") as the queue name to which a connection is to be
established.
Installing UNIX Network Software on Windows 98 and Me
Of the network software marketed by various software manufacturers, the software that
is to be used must integrate UNIX with personal computers, must allow the use of LPR,
and must enable Windows Driver to be connected to the LPR port.
The network software with which Xerox has confirmed connection capabilities is as
follows:
•
TCP/IP Direct Print Utility for Windows 95/98/Me (manufactured by Xerox).
Supplementary Information
Xerox printers support ftp to enable data files to be transmitted from Windows 98 and
Me computers to our printers. It is consequently possible to enter the ftp command in the
MS-DOS prompt and transfer files after the Windows Driver destination has been
specified as [FILE], and the plot data has generated a file on the disk. However, note that
data cannot be printed directly from applications in this case, and the ftp command
operations must always be carried out.