Xerox Versant 2100 Press, Быстрый старт

Страница: 33 / 68

6. Remove the new dry ink/toner cartridge from its packaging.
7. The dry ink/toner material inside the new cartridge is compact. Loosen and redistribute
the dry ink/toner material before placing into the dry ink/toner slot:
a) With one hand on either side of the cartridge, vigourously shake and rotate the
new cartridge up and down and then left and right for 30 seconds.
b) Test whether the dry ink/toner material is distributed sufficiently by turning the
white auger on the end of the cartridge.
c) If the auger does not turn easily, continue to shake the cartridge and loosen the
dry ink/toner material. When the auger does turn without resistance, the dry
ink/toner cartridge is ready to be installed.
8. Position the cartridge with the white auger end facing the press. Install the new dry
ink/toner cartridge by gently and evenly sliding the cartridge into the press until it
stops.
9. Close the dry ink/toner cover. If the cover does not close completely, make sure the
cartridge is in the lock position and is installed into the appropriate dry ink/toner
location.
Replacing the Waste Dry Ink/Toner Bottle
The Waste Dry Ink/Toner bottle collects dry ink/toner that accumulates during the
printing process. When the Waste bottle is full, a message displays on the press touch
screen informing you to exchange the full bottle with an empty one.
The press contains one waste bottle located at the front of the press behind the front
center door. When removing a full Dry Ink/Toner Waste bottle, SLOWLY pull it out of
the press. This will prevent any dry ink/toner from spilling out of the bottle.
Note
After you replace the Waste Dry Ink/Toner bottle, the system automatically resets the
HFSI usage counter for this CRU component to zero (0). Check the Consumables Supply
screen to verify the reset.
1. Ensure that the press is stopped (not running any jobs).
5-11 Xerox ® Versant™ 2100 Press
Quick Start Guide
Maintenance