Xerox PHASER 6140, Руководство пользователя

Страница: 35 / 170

Installation and Setup
Phaser 6140 Color Laser Printer
User Guide
35
Allowing the IP Address to be Assigned Automatically
If you have specified a static IP address and at some point want to re-enable automatic assigning of
the printer’s IP address, you can do this from the printer control panel.
1. On the printer control panel, press the
Menu
button.
2. Press the
Down Arrow
button to go to
Admin Menu
and then press the
OK
button.
3. At
Network Setup
, press
OK
.
4. Arrow down to
TCP/IP
and press
OK
.
5. Arrow down to
IPv4
and press
OK
.
6. At
Get IP Address
, press
OK
.
7. Arrow down to
DHCP/AutoIP
and press
OK
.
Assigning the IP Address Manually
These instructions are for assigning a static IP address to your printer from the printer’s control panel.
Once an IP address is assigned, you can change it using CentreWare IS.
To assign a static IP address to the printer:
1. You will need the following information to assign the IP address:
• An
IP address
properly configured for your network.
• The
Network Mask
address
• The default
Router/Gateway address
If you are on a network managed by a network administrator, contact your network administrator
to obtain the network information.
If you are on a home network that uses a router or other device to connect the printer to the
network, refer to the router/device documentation for instructions on assigning network addresses.
The router/device documentation should give you a range of acceptable address numbers you can
use. It is important that the addresses be similar to those used by other printers and computers on
the network, but not the same; only the last digit needs to be different. For example, your printer
can have the IP address 192.168.1.2 while your computer has the IP address 192.168.1.3. Another
device can have the IP address 192.168.1.4.
Note: To reduce the chance of the router assigning the printer’s static IP address to another
computer that obtains its IP address dynamically, give the printer an address at the higher end of
the address range allowed by the router/device. For example, if your computer has the IP address
192.168.1.2, and your router/device allows IP addresses up to 192.168.1.25, select an IP address
between 192.168.1.20 and 192.168.1.25.
2. On the printer control panel, press the Menu button.
3. Press the Down Arrow button to go to Admin Menu and then press the OK button.
4. At Network Setup , press OK .
5. Arrow down to TCP/IP and press OK .
6. Arrow down to IPv4 and press OK .
7. At Get IP Address , press OK .
8. Arrow down to Panel and press OK to enable this option.