Xerox DocuPrint 180 NPS Series, Руководство по планированию установки

Страница: 36 / 172

PRINTER COMPONENTS AND OPTIONS
3-8 XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 96/4635/180 NPS
Input enablement
Adding a third-party feeder to your DocuPrint system is made
possible by the input enablement option. The DocuPrint 96/4635
printers accept cut sheets from the feeding device through an entry
slot at the lower right side of the last feeder/stacker module.
The input enablement option provides extended paper feed
capability from third-party feeder devices. Sheets are received from
third party feeder devices through an entry slot located in the last
feeder/stacker module of the system.
The DP180 printer accepts cut sheets from the rear of the stacker
into a feeding device that replaces an existing high-capacity feeder
assembly.
Note: The DocuPrint 4635 can support a maximum of three feeder/
stackers with both the input enablement and the bypass transport.
The DocuPrint 96 can support a maximum of two feeder/stackers
with both the input enablement and the bypass transport. The
DocuPrint 180 can support a maximum of three feeder/stackers with
both the input enablement and the bypass transport. For the
DocuPrint 180, a maximum of four feeder/stackers can be supported
with the input enablement device only.
The following figure illustrates the system with the bypass transport
and the input enablement device.
Figure 3-10. Bypass transport module and input enablement
device
1 Bypass transport paper output location
2 Input enablement device paper input location