page-2
0015647-0001 February 18, 1999
Getting Started Guide
2.1 Normal Initialization Process
As the Splash color server initializes, the following sequence of events occur:
1. The green LED illuminates, indicating that power is on.
2. The Splash color server emits one long and two short beeps.
3. After about 30 to 45 seconds, the green activity light on the floppy drive illuminates
briefly and the Splash color server emits one short beep.
4. After about 45 seconds, the Splash color server emits six beeps; two short, two long, and
two short. This is a signal from the color server indicating that it is ready to accept the
Configuration disk. If the disk is not inserted, the color server continues to initialize.
The beeps are a normal part of the initialization process.
This time can vary if the Splash color server performs a disk check.
5. The status LED alternately flashes between yellow and red several times and then
changes to flashing yellow.
6. The Splash color server prints a startup Test Page.
When powering down the color server, wait for all jobs to complete, turn off the Splash color
server, and then turn off the copier.
2.2 Splash M Series Status Lights
Power LED
(green)
Status LED
LED
Description
Green, not flashing
Power indicator.
Amber, slowly
flashing
Splash M Series Color Server is idle. Normal
operation.
Amber, quickly
flashing
Splash M Series Color Server activity, such
as spooling, ripping, or printing.
Red, off
No problems.
Red, one flash
Add paper.
Red, two flashes
Toner or fuser oil problem.
Red, three flashes
Paper jam.
Red, four flashes
Door open, copier disconnected or other
similar error.
No amber or red
Hardware problem or floppy inserted at the
wrong time.
(amber
or red)
