Xerox C8 - DocuPrint Color Inkjet Printer, Руководство пользователя, Страница: 319 / 458

Calibration 305
Guidelines for Successful Calibration
To ensure your calibration is as accurate as possible, check the following
guidelines before you calibrate:
•
Ensure that your X-RiteColor® DTP32HS densitometer is connected
properly
•
Ensure that your X-RiteColor DTP32HS densitometer is calibrated.
You should calibrate the device at least once a week, or whenever the
power to the device is interrupted. Use the manufacturer calibration
chart supplied with the device. After you finish calibrating the device,
make sure you store the chart in the designated envelope.
•
To warm up the printer, use any media to print at least 25 duplex
sheets of any four color test job.
•
Print a reference job and use the same media and screen type on which
you will print the final job.
•
Prepare the calibration pad to measure the calibration charts. If a
calibration pad is not available, set a white media, at least 200 gsm, or
two sheets of lighter paper, on the surface. Read the calibration chart
on this surface.
•
Set the Spire CXP8000 color server emulation method to the method
you will use to print the customer job (CSA or Device Link).
The Calibration Process
The calibration process consists of the following steps:
1.
Calibrate the densitometer, see Calibrating the DTP32HS Densitometer
on page 306.
2.
Load the paper set you are going to use for printing in the Xerox
DocuColor 8000 Digital Color Press.
3.
In the Spire CXP8000 color server application, from the
Tools
menu,
select
Calibration
, see Calibrating the Spire CXP8000 Color Server on
page 311.
4.
Click
Calibrate
to run the Color Calibration Wizard, and to create a
calibration table.
For more information about the DTP32HS densitometer, see Calibrating the
DTP32HS Densitometer on page 306.