Xerox 3400N - Phaser B/W Laser Printer, Руководство по обслуживанию

Страница: 2 / 81

CAUTION Conditions that can result in damage to the product.
WARNING Conditions that can result in personal injury or loss of life.
For 110 VAC printers, do not apply more than 135 Volts RMS between
the supply conductors or between either supply conductor and ground. Use only the
specified power cord and connector. For 220 VAC printers, do not apply more than
264 Volts RMS between the supply conductors or between either supply conductor and
ground. Use only the specified power cord and connector. Refer to a qualified service
technician for changes to the cord or connector.
Avoid electric shock by contacting a qualified service
technician to replace fuses inside the product. Do not operate without the covers and
panels properly installed. Do not operate in an atmosphere of explosive gases.
WARNING Turning the power off using the On/Off switch does not de-energize
the printer. You must remove the power cord to disconnect the
printer from the mains. Keep the power cord accessible for removal
in case of an emergency.
Read all installation instructions carefully before you plug the
product into a power source.
CAUTION A personal injury hazard exists that may not be apparent. For
example, a panel may cover the hazardous area. Also applies to a
hazard to property including the product itself.
DANGER A personal injury hazard exists in the area where you see the sign.
Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if
you spill anything into the case, if product is exposed to any excess moisture, if product is
dropped or damaged, if you suspect that the product needs servicing or repair, and
whenever you clean the product.
Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a properly
grounded outlet.