- 6 -
Xentino SI305
– SI306
Quick Installation Guide
“focus differently”
www.xentino.com
DANGER:
Never attempt to view optical connectors that might be emitting laser energy.
Do not power up the laser product without connecting the laser to the optical
fiber and putting the cover in position, as laser outputs will emit infrared laser
light at this point.
Note:
1. The DC power should be connected to a well-fused power supply.
2. Input power should be within the range of 54~58VDC for PoE+ compliant, or 48-
58VDC for PoE compliant.
Pin No#
Status
5-Port with PoE (4TX+1TX-PoE)
5-Port (4TX+1SFP) with PoE
Pin 1
ON
To enable Broadcast storm rate limit
To enable Broadcast storm rate limit
OFF
To disable Broadcast storm rate limit
To disable Broadcast storm rate limit
Pin 2
ON
NOT USED
NOT USED
OFF
NOT USED
NOT USED
Ethernet Interface Connecting the (Fiber, SFP)
For a 100 Mbps fiber port available, please prepare the LC connectors or SC connectors (with the use of
an optional SC-to-LC adapter). They are also available with multimode, single mode, long-haul (for
connections up to 120+ km) or special-application transceivers.
For a 1000 Mbps fiber port available, please use the mini-GBIC SFP (small form pluggable). These
accept plug in fiber transceivers that typically have an LC style connector. They are available with
multimode, single mode, long-haul (for connections up to 80+ km) or special-application transceivers.
For each fiber port there is a transmit (TX) and receive (RX) signal. Please make sure that the transmit
(TX) port of the switch connects to the receive (RX) port of the other device, and the receive (RX) port of
the switch connects to the transmit (TX) port of the other device when making your fiber optic
connections.
Power Connecting
The switch can be powered from two power supply (input range 12V
– 58V). Insert the positive and
negative wires into V+ and V- contact on the terminal block and tighten the wire-clamp screws to prevent
the wires from being loosened.
DIP Switch Setting
