XENO XPTZ22IR, Руководство пользователя

Страница: 18 / 24

12
As the XPTZ22IR is defaulted to TARGET ID 1 (addressed), if you are using more
than 1 XPTZ22IR on the DVR, it is recommended that you connect the XPTZ22IR to
CH1 on your recording device to programme it and work in reverse order from the
highest number to the lowest e.g. XPT22IR required on DVR channels: 1, 5, 8, 12
–
the order of programming would be: 12, 8, 5, & 1.
DEVICE ID: This 6 digit number is unique to this camera
CHECK ID: This helps to distinguish between several domes on the same system (see
note on pg12)
TARGET ID: This is the address, 001 to 250
SOFT PROTOCOL: AUTO (Pelco-D & Pelco-P)
– this cannot be changed
BAUD RATE: 1200 / 2400 / 4800 / 9600
<COMM RESET>: Defaults the comm menu
SAVE: Save the settings within the COMM menu, failure to do so may mean having to
reprogram.
4.2.2 IR Display
WORKING MODE: AUTO / colour / black/white
TESTING TIME: Time between switching between colour and black/white and vice versa,
2s to 15s
OUTPUT POWER: select 40 / 60 / 80 / 100% for the IR output
ILLUMINATION ON: 1 to 15. This is the level at which the camera will switch between
colour to black/white and vice versa. 1 = switches to monochrome whilst there is a high
amount of ambient light. 15 = switches to monochrome whilst there is a low level of
ambient light.
AMBIENT LIGHT: This provides information only on the ambient light level and will change
depending on the available light.
IR SWITCH ZOOM: 1 to 10. The point at which the magnification of the XPTZ22IR
switches the IR illumination from short to long range (adaptive illumination).
<IR DISPLAY >
WORKING MODE AUTO
TESTING TIME 08S
OUTPUT POWER 100%
ILLUMINATION ON 3
AMBIENT LIGHT
IR SWITCH ZOOM 06
EXIT