XENO XDR5K4, Руководство по установке и эксплуатации

Страница: 186 / 187

186
FAQ
•
Why does my DVR make a beeping sound after booting?
The possible reasons for the warning beep on the DVR are as follows:
a) There is no HDD installed in the DVR.
b) The HDD is not initialized.
c) HDD error
To cancel the beeping sound and use the DVR without HDD, enter the Exception Settings interface. For detailed
information, see Chapter 9.4 to handling the exception.
•
Why does the DVR seem unresponsive when operating with the IR remote control?
Please read through the section Using the IR Remote Control , and check:
a) The batteries are installed correctly in the remote, making sure that the polarities of the batteries are not
reversed.
b) The batteries are fresh and are not out of power.
c) The remote has not been tampered with.
d) There are no fluorescent lamps in use nearby.
•
Why does the PTZ seem unresponsive?
If the PTZ seem unresponsive, please check:
a) The RS-485 cable is properly connected.
b) The dome decoder type is correct.
c) The dome decoder speed configuration is correct.
d) The dome decoder address bit configuration is correct.
e) That the main board RS-485 interface is not broken.
•
Why is there no video recorded after setting the motion detection?
If there are no recorded video after setting the motion detection, please check:
a) The recording schedule is setup correctly by following the steps listed in Configuring Record Schedule .
b) The motion detection area is configured correctly (See Setting up Motion Detection ).
c) The channels are being triggered for motion detection (See Setting up Motion Detection ).
•
Why doesn’t the DVR detect my USB export device for exporting recorded files?
There’s a chance that the DVR and your USB device is not compatible. Please refer to our company’s website to view a
list of compatible devices.