
X- O N E
19
INTERCONNECTION MASTER
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
• Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
• Connect the RCA jacks MASTER OUT of the MASTER amp with the RCA jacks SLAVE IN of the SLAVE amp with appropriate
high-value RCA cables.
• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use therefore cable with a minimum profile section of 0,5 mm
2
.
INTERCONNECTION SUBWOOFER
• Attend page 22.
SETTINGS MASTER
• The SLAVE IN/MASTER OUT switch should be in MASTER OUT position.
Observe the informations of LOW PASS, SUB SONIC, LEVEL, BASS BOOST, FREQ RANGE and BASS REMOTE on page 18.
SETTINGS SLAVE
• The SLAVE IN/MASTER OUT switch should be in SLAVE IN position
In SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
INTERCONNECTION EXAMPLE Master/Slave Mode
Connect Stereo RCA output (L/R or SUB OUT) of the headunit
with the LINE INPUT L & R of the MASTER amp
Switch position MASTER OUT
MASTER
Switch position SLAVE IN
Connect Stereo RCA output MASTER OUT of the MASTER amp
with the RCA input SLAVE IN of the SLAVE amp.
Connect the bass remote controller
and the remote terminal at the amplifier
(MASTER) with the enclosed cable.
L
R
SLAVE