User Manual - DINgate TM
26 October 2021
XEMEX Confidential
Page 5 of 20
1
Introduction
1.1
Scope
This manual is applicable to DINgate TM (Transparent Modem), a communication gateway to connect an RS485
device via a wireless communication link.
It describes the specifications, installation and operation of the product. Please read this document carefully before
installation and operating.
1.2
Target group
The installation and the operation of this device and any maintenance must be carried out by a qualified person in
accordance with specific local standards and safety regulations.
1.3
Disclaimer
The information in this document is subject to change without notice and should not be construed as a promise by
Xemex. Xemex assumes no liability for possible errors in this document. In no event shall Xemex be liable for direct,
indirect, special, incidental, or consequential damages of any kind arising out of the use of this document, nor shall
Xemex be liable for incidental or consequential damages arising out of the use of this document, described software
or hardware.
1.4
Applicable product versions
This manual is applicable for following product versions:
Product version
Description
DINgate 1.0
–
TM
4G Cat-1 with GPRS fallback communication gateway for ABB B21/B23 E-meters
DINgate 1.1
–
TM
4G Cat-M communication gateway for ABB B21/B23 E-meters
1.5
Intended usage
The DINgate TM module is used to access a 2-wire RS485 bus via a remote IP link. Data is forwarded transparently
from the modem to the RS485 interface and vice versa.
1.6
Technical assistance
In case technical assistance is needed, contact Xemex NV:
XEMEX NV
Metropoolstraat 11a
B-2900 Schoten
Belgium
Tel: +32 201 95 95
E-mail:
1.7
Used symbols
Following symbols are used in this document and/or are marked on the product:
Alternating current
