5. Parameters Setting
long press
button for 5 seconds
At the setting interface, keep pressing the
button for 5 seconds, the
figure flickers, it means the controller enters into the setting mode. At this time,
you can press the
,
button to adjust the parameters.
After finish setting the parameters, shortly press the
button and the
controller will save the set parameters automatically.
At this interface, when there is no operation for 20 seconds, it will automatically
exit the setting mode, cancel to save the parameters and return to the main
interface.
Clear the accumulative
generating AH of solar
panel
Clear the accumulative
discharging AH of load
Battery
stop
charge
voltage setting
Battery
low
voltage
recovery setting
Battery
low
voltage
protection setting
Factory reset:
At the battery voltage interface, keep pressing three buttons (
,
,
) for 5 seconds until the interface
displays
, , it means the controller has finished factory reset.
At the setting interface, keep pressing the
button for 5 seconds, the
figure flickers, it means the controller enters into the setting mode. At this time,
you can press the
、
button to adjust the parameters.
After finish setting the parameters, shortly press the
button and the
controller will save the set parameters automatically.
At this interface, when there is no operation for 20 seconds, it will automatically
exit the setting mode, cancel to save the parameters and return to the main
interface.
As shown above, the left
arrow
static
display
means it is in direct
charge; the left arrow
flickers means it is in
float charge. If the left
arrow without display
means it is no charge.
The load output switch
default ON. At the
battery voltage interface,
you can press the
button to turn on or turn
off the load.
After pressing the
button, the load is
disconnected and the
load output is stopped.
[0h] Manual mode
[1-23h]
Light
control
delayed mode
[24h] Light control mode
Lead-acid battery
b-1 AGM
b-2 GEL
b-3 OPEN
Temperature
compensation setting
6. Trouble Shooting
Low voltage early
alarm
When the voltage of the battery less than 11V (×2/24V), the
icon appears in the
bottom of the LCD.
