99 cannot be selected as these are preset with the priority and NOAA weather
frequencies respectively.
Pressing the F/CH knob scrolls between memory channel selection and frequency
adjustment. The selected item flashes to indicate adjustment. Rotate the F/CH
knob to adjust the selected item up or down.
To store the frequency in the currently selected memory channel, press and hold
the MEM button for 2 seconds. The display will show
to indicate
successful entry.
To exit the memory programming screen, press
Ú
.
Clearing Memories – To erase all memory channels, excluding the Priority and
NOAA weather channels, turn off the unit by holding the ON button for 2 seconds
and then, while holding the MEM button, turn the unit on by pressing the ON
button. The display will show
Erased
and then return to the default screen and all
memory channels will be reset.
To clear individual channels, enter memory programming mode and adjust the
channel MHz. value down below the lowest available MHz. value (108 MHz. if VOR
Receive is activated or 118 MHz. if VOR Receive is deactivated). The word CLEAR
will appear in the display.
Press and hold the MEM button for 2 seconds. The display will show
and
the channel will be cleared.
To exit the memory programming screen, press
Ú
.
Memory Scanning
Introduction - The XCOM 760 has 99 user programmable memory channels,
stored in non-volatile memory. These channels can be scanned sequentially. If a
signal is received in a channel, the scanning is paused. Scanning resumes 3
seconds after the signal is lost.
Starting Memory Scan – While viewing memories (see MEM section above),
press the F/CH knob to start memory scanning. The number of channels scanned
is determined by the ScanCH setting. This can be altered in the MODE as detailed
above. Note that the Priority channel (CH 0) is always scanned.
Setting a ScanCH value of 10 indicates that the first 10 memory channels will be
scanned, in addition to the Priority channel.
Stopping Memory Scan – Pressing the F/CH knob a second time will cease
scanning. Scanning will also be terminated if a PTT is pressed or if the MODE
button is pressed.
Release 1.7
© XCOM Avionics 2005
www.xcom760.com Page
13
