XCAT Basic, Руководство пользователя

Страница: 7 / 40

Introduction and important notes
Manual XCAT Basic Page 7 Edition: 05/2023
1.4 Important notes on transport and storage
Secure the XCAT during transport, e.g. on the roof of the car, using suitable
fastening material, e.g. the XCAT transport kit.
Check the tensioning straps regularly and retighten them if necessary.
Observe the instructions in the manuals for your vehicle and the roof rack
system, particularly with regard to maximum roof loads and maximum
speeds.
If you store the hulls on the car roof for a long time, loosen the tension
straps so that the hulls do not warp permanently.
Also, when storing the hulls in other rooms such as garage, basement, etc.,
do not fix the hulls with tension belts.
Do not use tensioning straps with ratchet, as there is a risk that the hulls will
be damaged by excessive tensioning. Therefore, only use tensioning straps
with a simple clamping lock.
If the hulls are colder than the center and side beams after transport,
assembly may be difficult because the distances no longer match due to
different expansion coefficients. In this case, store all parts at the same
temperature for some time before assembly.
Clean the boat after each use. Free it from salt residues or stones to prevent
possible damage.
Always rinse all parts with fresh water after use in salt water.
A plastic polishing compound can be used to polish the hulls for heavier dirt.
Always store the hulls with the keel upwards so that water does not
permanently run into the flanges.
Do not store the hulls permanently in the sun on one side, otherwise they
may warp.
Do not store the hulls in the sun under a cover. This can cause heat buildup
and warping of the hulls.